THEFT-DETERRENT SIREN OUTLINE
id0914b5870200
• The theft-deterrent siren is located on the rear, left side of the trunk lid (4SD) or liftgate (5HB, WGN).
• Controlled by the following vehicle conditions:
-
- Standard alert control
-
- Open circuit alert control
Standard Alert Control
• The siren beeps when receiving an alert initialization signal from the theft-deterrent control module. When a go-to-initial signal is received the siren is stopped.
|
1
|
Theft-deterrent control module
|
|
2
|
Theft-deterrent siren
|
|
3
|
Alert initialization signal
|
|
4
|
Siren beeps
|
Open Circuit Alert Control
• A back-up power supply is integrated in the theft-deterrent siren.
• When an open circuit is detected in the related wiring harness, the theft-deterrent siren beeps using the back-up power supply.
• If any one of the following conditions are met, the siren is stopped:
-
- Detects that all related wiring harness are propeLRy connected.
-
- Receives go-to-initial signal from the theft-deterrent control module.
|
1
|
Theft-deterrent control module
|
|
2
|
Theft-deterrent siren
|
|
3
|
Siren beeps
|
|
4
|
Siren stops
|
|
5
|
Approx. 30 seconds
|
|
6
|
Approx. 5 seconds
|
|
7
|
Maximum 9 cycles
|