REAR BRAKE (DISC) INSPECTION
id041100800400
Brake Judder Repair Hint
1. (See FRONT BRAKE (DISC) INSPECTION.)
Rear disc plate runout limit
-
0.05 mm {0.002 in}
Disc Plate Thickness Inspection
-
Caution
-
• Excessive runout may result if the disc plate is removed from the vehicle and then machined. Machine the disc plate while installed on the vehicle.
1. Measure the thickness of the disc plate.
-
• If the thickness is not within the specification, replace the disc plate.
Minimum rear disc plate thickness
-
8 mm {0.31 in}
Minimum rear disc plate thickness after machining using a brake lathe on-vehicle
-
8.8 mm {0.35 in}
Disc Pad Thickness Inspection
1. Jack up the front of the vehicle and support it with safety stands.
2. Remove the wheel and tires.
3. Verify the remaining thickness of the pads.
Minimum rear disc pad thickness
-
2.0 mm {0.079 in} min.
4. Replace the pads as a set: right and left wheels, if either one is at or less than the minimum thickness.
