1. The removal and installation procedures for the wheels and tires are not mentioned in this section. When a wheel is removed, tighten it to
88-118 N·m {9.0-12.0 kgf·m, 65.0-87.0 ft·lbf}.
1. If any power steering fluid line has been disconnected anytime during the procedure, add ATF M-III or equivalent (e.g. Dexron®II), bleed the fluid lines, and inspect for leakage after the procedure has been completed.
1. Disconnect the negative battery cable before doing any work that requires handling of connectors. Reconnect the negative battery cable only after the work is completed.
1. Tighten any part of the suspension that uses rubber bushings only after vehicle has been lowered and unloaded.