DTC 06:ER10

id0902f6817900

DTC 06:Er10

CD changer (upper module)-base unit communication line

DETECTION CONDITION

• Base unit detects communication error with CD changer (upper module).

POSSIBLE CAUSE

• Malfunction of connectors between base unit and CD changer (upper module)
• CD changer (upper module) malfunction
• Base unit malfunction

Diagnostic procedure

STEP

INSPECTION

ACTION

1
INSPECT CONNECTOR
• Remove CD changer (upper module) and inspect connector for the following.
- Deformation of pin
- Poor connection of female terminal
- Pinching of foreign material
• Is connector okay?
Yes
Go to next step.
No
Repair connector, then go to next step.
2
VERIFY THAT CD CHANGER (UPPER MODULE) IS INSTALLED WITH BASE UNIT
• Install CD changer (upper module) and verify its installation condition.
• Is CD changer (upper module) securely installed?
Yes
Go to next step.
No
Securely install CD changer (upper module), then go to next step.
3
INSPECT CD CHANGER (UPPER MODULE)
• Clear DTC.
• Turn ignition switch to ACC or ON position and hold for 3 seconds or more.
• Start on-board diagnostic test mode.
• Is DTC 06:Er10 displayed?
Yes
Replace base unit and CD changer (upper module).
No
Troubleshooting completed.