DTC 07:ER10

id0902f6818400

DTC 07:Er10

MD player-base unit communication line

DETECTION CONDITION

• Base unit detects communication error with MD player.

POSSIBLE CAUSE

• Malfunction of connectors between base unit and MD player
• MD player malfunction
• Base unit malfunction

Diagnostic procedure

STEP

INSPECTION

ACTION

1
INSPECT CONNECTOR
• Remove MD player and inspect connector for the following.
- Deformation of pin
- Poor connection of female terminal
- Pinching of foreign material
• Is connector okay?
Yes
Go to next step.
No
Repair connector, then go to next step.
2
VERIFY THAT MD PLAYER IS INSTALLED WITH BASE UNIT
• Install MD player and verify its installation condition.
• Is MD player securely installed?
Yes
Go to next step.
No
Securely install MD player, then go to next step.
3
INSPECT MD PLAYER
• Clear DTC.
• Turn ignition switch to ACC or ON position and hold for 3 seconds or more.
• Start on-board diagnostic test mode.
• Is DTC 07:Er10 displayed?
Yes
Replace base unit and MD player.
No
Troubleshooting completed.