DISC PAD (REAR) REPLACEMENT
id041100800300
1. Switch to the maintenance mode. (See MAINTENANCE MODE.)
2. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITHOUT i-stop)].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].)
3. Remove the wheel and tire. (See WHEEL AND TIRE REMOVAL/INSTALLATION.)
4. Disconnect the electric parking brake motor gear unit connector.
am3zzw00019750
|
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
7. End the maintenance mode. (See MAINTENANCE MODE.)
8. After installation, pump the brake pedal a few times and inspect the following:
am3zzw00019751
|
1
|
Bolt
(See Bolt Removal Note.)
|
2
|
Disc pad
|
Bolt Removal Note
1. Remove the bolt shown in the figure and lift up the caliper.
am3zzw00019752
|
Disc Pad, Bolt Installation Note
1. Clean the exposed area of the piston.
2. Push the piston in using the commercially available disc brake expand tool.
am3zzw00019753
|
3. Install the disc pads to the mounting support.
4. Return the caliper to the original position and install the bolt.
am3zzw00019754
|