BONNET LATCH SWITCH INSPECTION

id091400510600

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITHOUT i-stop)].)

2.  Remove the following parts:

(1)  Set plate (See SET PLATE REMOVAL/INSTALLATION.)

(2)  Front bumper (See FRONT BUMPER REMOVAL/INSTALLATION.)

(3)  Intake air guide (See INTAKE AIR GUIDE REMOVAL/INSTALLATION.)

(4)  Front combination light (See FRONT COMBINATION LIGHT REMOVAL/INSTALLATION.)

(5)  Shroud upper member (See SHROUD UPPER MEMBER REMOVAL/INSTALLATION.)

(6)  Crash zone sensor cover (See CRASH ZONE SENSOR REMOVAL/INSTALLATION.)

3.  Disconnect the bonnet latch switch connector. (See BONNET LATCH AND RELEASE LEVER REMOVAL/INSTALLATION.)

4.  Verify that the continuity is as indicated in the table.

Note

•  Inspect the continuity when the bonnet is open and closed.

ac5wzw00000387

am6zzw00008503

•  If the operation as indicated in the table cannot be verified, replace the bonnet latch.