WIRING HARNESS REPAIR (VARIOUS CAUTIONS ON SERVICING WIRING HARNESS SYSTEMS)
id007000000300
Purpose of Adoption
• Servicing improvement by use of repair-use connectors.
Service Point
• Cut off approx. 10 to 20 mm of the insulation from the ends of the wiring harness on the vehicle side and the wiring harness of the repair-use connector and apply solder. Set the heat shrinkable tubing to the soldered area and shrink the heat shrinkable tubing at a temperature of approx. 100 degrees C using a drier.
Common Inquiry
• Not applicable
Other
• Not applicable