CLUSTER SWITCH REMOVAL/INSTALLATION

id091700460800

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITHOUT i-stop)].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].)

2.  Remove the front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

3.  Remove the front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

4.  Remove bolt A.

am6xuw00006306

5.  Pull the driver-side lower panel in the direction of the arrow in the order of (1), (2) while detaching clip B, hooks C and pin D.

6.  Set the driver-side lower panel aside.

7.  Remove the hooks E in the direction of the arrow in the order of (3), (4) shown in the figure.

am6xuw00006307

8.  Remove the hooks F in the direction of the arrow in the order of (5), (6) shown in the figure.

9.  Remove the cluster switch in the direction of the arrow (7) shown in the figure.

10.  Disconnect the cluster switch connector.

11.  Install in the reverse order of removal.