COMMANDER SWITCH REMOVAL/INSTALLATION

id092000811300

Caution

•  The audio unit determines the presence/non-presence of a commander switch and records it based on the communication status when the ignition is switched ON (engine off or on) or to the ACC position for the first time after the negative battery cable is connected.

•  If the negative battery cable is connected while the audio unit has recorded the non-presence of the commander switch and thereafter a commander switch is installed, the installed commander switch will not operate.

•  When installing or removing the commander switch, always disconnect the negative battery cable, and after the servicing is completed, switch the ignition to ACC or ON (engine off or on) to allow the audio unit to record the presence/non-presence of the commander switch.

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITHOUT i-stop)].)

2.  Remove the upper panel (See UPPER PANEL REMOVAL/INSTALLATION.)

3.  Disconnect the connector.

am6zzw00009732

4.  Remove the screws.

5.  Remove the commander switch component from the upper panel.

6.  Remove the commander switch screws.

ac5wzw00000369

7.  Remove the commander switch from the bracket.

8.  Install in the reverse order of removal.