REAR MOUNT CAMERA INSPECTION

id092000815000

Type displaying predicted vehicle track

Note

•  The rear mount camera cannot be inspected as an individual unit. If the rear mount camera does not display images normally, refer to the symptom troubleshooting. (See DISPLAY DOES NOT CHANGE TO THE REAR MOUNT CAMERA IMAGE. [ENTIRE AUDIO SYSTEM].)

Type displaying fixed lines

4SD

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITHOUT i-stop)].)

2.  Remove the following parts:

(1)  Liftgate recess (See LIFTGATE RECESS REMOVAL/INSTALLATION.)

(2)  Trunk lid trim (See TRUNK LID TRIM REMOVAL/INSTALLATION.)

(3)  Rear mount camera (See REAR MOUNT CAMERA REMOVAL/INSTALLATION.)

3.  Prepare four dry cell batteries (1.5 V)

4.  Connect the four dry cell batteries in a series.

ac5wzw00005108

5.  Connect the positive pole of the dry cell battery to rear mount camera terminal A, and the negative pole to terminal E.

ac5wzw00004640

6.  With the cell batteries being connected, measure the waveform between rear mount camera terminal C and terminal D.

7.  Verify that waveform A shown in the figure is displayed two times or more.

ac9wzw00002991

8.  If the voltage is not as shown in the figure, replace the rear mount camera.

WGN

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITHOUT i-stop)].)

2.  Remove the following parts:

(1)  Liftgate upper trim (See LIFTGATE UPPER TRIM REMOVAL/INSTALLATION.)

(2)  Liftgate side trim (See LIFTGATE SIDE TRIM REMOVAL/INSTALLATION.)

(3)  Liftgate lower trim (See LIFTGATE LOWER TRIM REMOVAL/INSTALLATION.)

(4)  Liftgate garnish (See LIFTGATE GARNISH REMOVAL/INSTALLATION.)

(5)  Rear mount camera (See REAR MOUNT CAMERA REMOVAL/INSTALLATION.)

3.  Prepare four dry cell batteries (1.5 V)

4.  Connect the four dry cell batteries in a series.

ac5wzw00005108

5.  Connect the positive pole of the dry cell battery to rear mount camera terminal A, and the negative pole to terminal E.

ac5wzw00004640

6.  With the cell batteries being connected, measure the waveform between rear mount camera terminal C and terminal D.

7.  Verify that waveform A shown in the figure is displayed two times or more.

ac9wzw00002991

8.  If the voltage is not as shown in the figure, replace the rear mount camera.