Bluetooth UNIT REMOVAL/INSTALLATION

id092000833300

Caution

•  The audio unit determines the presence/non-presence of a Bluetooth unit and records it based on the communication status when the ignition is switched ON (engine off or on) or to the ACC position for the first time after the negative battery cable is connected.

•  If the negative battery cable is connected while the audio unit has recorded the non-presence of the Bluetooth unit and thereafter a Bluetooth unit is installed, the installed Bluetooth unit will not operate.

•  When installing or removing the Bluetooth unit, always disconnect the negative battery cable, and after the servicing is completed, switch the ignition to ACC or ON (engine off or on) to allow the audio unit to record the presence/non-presence of the Bluetooth unit.

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITHOUT i-stop)].)

2.  Remove the glove compartment. (See GLOVE COMPARTMENT REMOVAL/INSTALLATION.)

3.  Remove the nuts.

am6zzw00009733

4.  Disconnect the connector.

5.  Remove the Bluetooth unit.

6.  Install in the reverse order of removal.