CONTROL SYSTEM PERSONALIZATION FEATURES SETTING PROCEDURE

id094000439800

1.  Connect the M-MDS to DLC-2.

2.  After the vehicle is identified, select the following items from the initial screen of the M-MDS.

•  Select the “Module Programming”.
•  Select “Programmable Parameters”.
•  Select menu in the R_BCM.

3.  Select an item name, and then select option.


Security And Locks


Power door lock system

M-MDS display

Function

Initial setting

Setting contents

Control unit
Auto Door Lock Mode.
Auto door lock function can be changed.
Lock: Driving, Unlock: IGN Off.
Not Adopted./OFF/Lock When Driving./Lock: Driving, Unlock: IGN Off./Lock When Shifting Out Of P./Lock: Shift From P, Unlock: In P.
Rear body control module (RBCM)


Lighting Systems


Turn light system

Australian, European (L.H.D. U.K.), Israel specs.

M-MDS display

Function

Initial setting

Setting content

Control unit
Three-Flash Turn Signal.
The turn light system can be switched between operable and inoperable.
ON
Not Adopted./OFF/ON
Rear body control module (RBCM)

Except Australian, European (L.H.D. U.K.), Israel specs.

M-MDS display

Function

Initial setting

Setting content

Control unit
Three-Flash Turn Signal.
The turn light system can be switched between operable and inoperable.
OFF
Not Adopted./OFF/ON
Rear body control module (RBCM)


Auto light system

M-MDS display

Function

Initial setting

Setting content

Control unit
Auto-headlight On.
Auto light sensor sensitivity can be changed.
Medium
Not Adopted./Dark/Medium Dark/Medium/Medium Light/Light
Rear body control module (RBCM)

Note
•  If the mode is set to “Light” and “Medium Light”, the illumination level for illuminating the TNS and headlight increases. Therefore, the TNS and headlights illuminate when the ambient light is brighter than when the level is set to “Medium”. In addition, if the mode is set to “Medium Dark” and “Dark”, the illumination level for illuminating the TNS and headlights decreases. Therefore, the TNS and headlights illuminate when the ambient light is lower than when the level is set to “Medium”.


Room Light Control System

M-MDS display

Function

Initial setting

Setting content

Control unit
Interior Light Timeout-Door Open.
•  The front/rear map light and courtesy light illumination time after any door is open can be changed.
•  The trunk compartment light (4SD)/cargo compartment light (WGN) illumination time after trunk (4SD)/liftgate (WGN) is open can be changed.
30 minutes.
Not Adopted./30 minutes./60 minutes./10 minutes.
Rear body control module (RBCM)
Interior Light Timeout-Door Closed.
The front/rear map light and courtesy light illumination time after all door are closed can be changed.
15 seconds.
Not Adopted./15 seconds./7.5 seconds./30 seconds./60 seconds.
Rear body control module (RBCM)


Wiper/washer System


Auto wiper system

M-MDS display

Function

Initial setting

Setting content

Control unit
Rain Sensing Wipers.
The auto wiper function can be disabled.
On (Rein Sensing)
Not Adopted./Off*1 (Intermittent)/On (Rein Sensing)
Rear body control module (RBCM)

*1  :If the function is set to “Off”, the wipers will operate intermittently with the wiper switch in AUTO position.