DTC B11D4:08 [DYNAMIC STABILITY CONTROL (DSC)]
id0402b2894100
|
DTC
|
B11D4:08
|
Laser sensor
|
|
|
DETECTION CONDITION
|
• Correct signal cannot be received from laser sensor.
• DSC HU/CM received excessively-continuous signal from laser sensor.
|
||
|
FAIL-SAFE FUNCTION
|
• Refer to “Fail-safe Function Malfunction Contents”. (See DTC TABLE [DYNAMIC STABILITY CONTROL (DSC)].)
|
||
|
POSSIBLE CAUSE
|
• Laser sensor malfunction
• DSC HU/CM malfunction
|
||
|
SYSTEM WIRING DIAGRAM
|
—
|
||
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY LASER SENSOR DTC
• Using the M-MDS, perform the laser sensor DTC inspection.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE [LASER SENSOR].)
DTC troubleshooting completed, then go to the next step
|
|
No
|
Go to the next step.
|
||
|
2
|
VERIFY DTC TROUBLESHOOTING COMPLETED
• Using the M-MDS, clear the DTC from the DSC HU/CM.
• Using the M-MDS, perform the DSC HU/CM DTC inspection.
• Is the same DTC present?
|
Yes
|
Repeat the inspection from Step1.
If the malfunction recurs, replace the DSC HU/CM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY NO DTC IS PRESENT
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
DTC troubleshooting completed.
|
||