KOEO/KOER SELF TEST [MZR-CD (RF Turbo)]

id0102f1801200

KOEO Self Test

Note

• After performing the KOEO self test, the following conditions may occur. If these conditions occur, perform a separate inspection of the applicable module DTC, and commence repairs.

― The DSC indicator light illuminates, the DSC OFF light flashes, and DTC C0051:54 is stored in the DSC HU/CM (With DSC)

― The AFS OFF light flashes. (With AFS (Adaptive Front Lighting System))

― DTC B10D7:94 is stored in the keyless control module. (With advanced keyless entry and push start button system)

1. Connect the M-MDS to the DLC‐2.

am6zzw00000122

2. After the vehicle is identified, select the following items from the initial screen of the M-MDS.

• When using the IDS (laptop PC)

1. Select “Self Test”.

2. Select “Modules”.

3. Select “PCM”.

• When using the PDS (Pocket PC)

1. Select “Module Tests”.

2. Select “PCM”.

3. Select “Self Test”.

3. Then, select the “KOEO On Demand Self-Test” and perform procedures according to directions on the M-MDS screen.

4. Verify the DTC according to the directions on the M-MDS screen.

• If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.

5. After completion of repairs, clear all DTCs stored in the PCM, while referring to “AFTER REPAIR PROCEDURE“.

KOER Self Test

Note

• Warm up until the exhaust gas temperature (EXHTEMP1, EXHTEMP2, EXHTEMP3 PID) is 100 °C {212 °F} or more before performing "KOER SELF TEST”.

• After performing the KOER self test, the following conditions may occur. If these conditions occur, perform a separate inspection of the applicable module DTC, and commence repairs.

― The DSC indicator light illuminates, the DSC OFF light flashes, and DTC C0051:54 is stored in the DSC HU/CM/ (With DSC)