DTC P167B:00 [MZR-CD 2.2]
id0102f3150000
|
DTC P167B:00 |
Fuel injector learning not done |
|---|---|
|
DETECTION CONDITION
|
• Injection amount correction does not complete.
Diagnostic support note
• The MIL does not illuminate.
• The DTC is stored in the PCM memory.
• Can not clear DTC from PCM memory by battery disconnected.
|
|
POSSIBLE CAUSE
|
• Injection amount correction procedure has not been completed.
• PCM internal memory malfunction
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY FREEZE FRAME DATA AND DIAGNOSTIC MONITORING TEST RESULTS HAS BEEN RECORDED
• Has FREEZE FRAME DATA been recorded?
|
Yes
|
Go to the next step.
|
|
No
|
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
|
||
|
2
|
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
• Verify related Service Information availability.
• Is any related Service Information available?
|
Yes
|
Perform the repair or diagnosis according to the available Service Information.
• If the vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
PERFORM INJECTION AMOUNT CORRECTION PROCEDURE
• Perform the injection amount procedure again.
• Start the engine.
• Verify that the glow indicator light condition.
• Do the glow indicator light turn off?
|
Yes
|
Go to the next step.
|
|
No
|
Fuel injector adjustment procedure (fuel injector data reset and fuel injector code program etc.) again.
Then go to the next step.
|
||
|
4
|
VERIFY TROUBLESHOOTING OF DTC P167B:00 COMPLETED
• Make sure to reconnect all disconnected connectors.
• Switch the ignition to ON (engine off).
• Clear the DTC from PCM memory using the M-MDS.
• Start the engine.
• Is the PENDING CODE for this DTC present?
|
Yes
|
Replace the PCM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
5
|
VERIFY AFTER REPAIR PROCEDURE
• Perform “AFTER REPAIR PROCEDURE”.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE [MZR-CD 2.2])
|
|
No
|
Troubleshooting completed.
|
||