DTC P252F:00 [MZR-CD 2.2]

id0102f3154300

DTC P252F:00

Engine oil level too high

DETECTION CONDITION

•  The PCM calculates engine oil attenuation based on fuel injection amount during diesel particulate filter regeneration. If the calculated engine oil attenuation amount is more than 20 %, the PCM determines that the engine oil amount level is too high.

Diagnostic support note

•  The FREEZE FRAME DATA is not available.

•  The DTC is stored in the PCM memory.

POSSIBLE CAUSE

•  Engine oil attenuation by frequently diesel particulate filter regeneration

•  Engine oil data reset procedure does not perform in each engine oil replacements

DTC P252F:00	Engine oil level too high
DETECTION CONDITION	• The PCM calculates engine oil attenuation based on fuel injection amount during diesel particulate filter regeneration. If the calculated engine oil attenuation amount is more than 20 %, the PCM determines that the engine oil amount level is too high. Diagnostic support note • The FREEZE FRAME DATA is not available. • The DTC is stored in the PCM memory.
POSSIBLE CAUSE	• Engine oil attenuation by frequently diesel particulate filter regeneration • Engine oil data reset procedure does not perform in each engine oil replacements

Diagnostic procedure

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA HAS BEEN RECORDED • Has FREEZE FRAME DATA been recorded?	Yes	Go to the next step.
1		No	Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2	VERIFY RELATED SERVICE INFORMATION • Verify related Service Information availability. • Is any related Service Information available?	Yes	Perform repair or diagnosis according to available Service Information. • If vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	VERIFY ENGINE OIL AMOUNT • Inspect the engine oil amount. • Is the engine oil amount above X line on dipstick?	Yes	Adjust the specified engine oil. (See ENGINE OIL REPLACEMENT [MZR-CD 2.2].) Perform the engine oil data reset procedure. Then go to Step 5.
3		No	Go to the next step.
4	VERIFY ENGINE OIL DATA RESET PROCEDURE COMPLETE • Does the engine oil data reset procedure each engine oil replacements?	Yes	Go to the next step.
4		No	Perform the engine oil data reset procedure. Then go to the next step.
5	VERIFY TROUBLESHOOTING OF DTC P252F:00 COMPLETED • Make sure to reconnect all disconnected connectors. • Switch the ignition to ON (engine off). • Clear the DTC from PCM memory using the M-MDS. • Start the engine. • Is the PENDING CODE for this DTC present?	Yes	Replace the PCM, go to the next step. (See PCM REMOVAL/INSTALLATION [MZR-CD 2.2].)
5		No	Go to the next step.
6	VERIFY AFTER REPAIR PROCEDURE • Perform “AFTER REPAIR PROCEDURE”. (See AFTER REPAIR PROCEDURE [MZR-CD 2.2].) • Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [MZR-CD 2.2])
6		No	Troubleshooting completed.