BOOST SENSOR INSPECTION [MZR-CD (RF Turbo)]

id0140f1445700

Note

•  Perform the following test only when directed.

Visual Inspection

1.  Inspect the boost sensor for damage and cracks.

•  If not as specified, replace the boost sensor.

2.  Inspect vacuum hose for improper routing, kinks or leakage.

•  If there is any malfunction, repair or replace suspected hose.

Sensor Output Value Inspection

1.  Switch the ignition to ON.

2.  Monitor the MAP PID using the M-MDS.

―  If not as specified, replace the boost sensor. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZR-CD (RF Turbo)].)

3.  Start the engine and warm up the engine completely.

4.  Monitor the MAP PID using the M-MDS at idle.

―  If not as specified, replace the boost sensor. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZR-CD (RF Turbo)].)