FUEL PRESSURE SENSOR INSPECTION [MZR-CD (RF Turbo)]


id0140f1801300

Note
•  Perform the following test only when directed.

Voltage Inspection

1.  Start the engine and warm up the engine completely.

2.  Measure the voltage between fuel pressure sensor terminals A and B using a voltmeter at idle.

Specification
1.41.7 V
―  If not as specified, replace the common rail. (See SUPPLY PUMP REMOVAL/INSTALLATION [MZR-CD (RF Turbo)].)
am3zzw00004088

3.  Turn off the engine and wait three minutes.

4.  Switch the ignition to ON.

5.  Measure the voltage between fuel pressure sensor terminals A and B using a voltmeter.

Specification
0.91.1 V
―  If not as specified, replace the common rail. (See SUPPLY PUMP REMOVAL/INSTALLATION [MZR-CD (RF Turbo)].)