ACCELERATOR PEDAL POSITION (APP) SENSOR INSPECTION [MZR-CD (RF Turbo)]

id0140f1803200

Note
•  Perform the following inspection only when directed.

Sensor Output Value Inspection

1.  Connect the M-MDS to the DLC‐2.

am6zzw00000122

2.  Switch the ignition to ON.

3.  Select APP1 or APP2 PID (percentage) on the M-MDS.

4.  Verify that the APP1 or APP2 PID (percentage) changes smoothly while accelerator pedal is gradually depressed.

•  If as verified, go to next step.
•  If not as verified, perform the “Circuit Open/Short Inspection”.

5.  Verify that the APP1 or APP2 PID (percentage) is as indicated in the table below according to the condition of the accelerator pedal.

―  If not as specified, replace the APP sensor. (See ACCELERATOR PEDAL COMPONENT REMOVAL/INSTALLATION [MZR-CD (RF Turbo)].)

Specification

Condition

APP1 PID (%)

APP1 PID (V)

APP2 PID (%)

APP2 PID (V)
Accelerator pedal is released
0
Approx. 1.04
0
Approx. 1.58
Accelerator pedal is depressed
100
Approx. 3.35
100
Approx. 3.89