NO.31 M RANGE POSITION INDICATOR LIGHT DOES NOT ILLUMINATE IN M RANGE/M RANGE POSITION INDICATOR LIGHT ILLUMINATE IN D RANGE [FS5A-EL]

id050308813300

31
M range position indicator light dose not illuminate in M range/M range position indicator light illuminate in D range
DESCRIPTION
•  M range position indicator light in instrument cluster dose not illuminate in M range or M range position indicator light in instrument cluster in D range with the ignition at ON.
POSSIBLE CAUSE
•  M range switch or related wiring harness malfunction.
Note
•  Before following the troubleshooting steps, make sure that the Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted. (See BASIC INSPECTION [FS5A-EL].)

Diagnostic procedure

STEP

INSPECTION

ACTION
1
Inspect the MNL SW PID value using the M-MDS.
(See PID/DATA MONITOR INSPECTION [FS5A-EL].)
Is the MNL SW PID value normal?
Yes
Inspect the instrument cluster.
(See INSTRUMENT CLUSTER INSPECTION.).
No
Inspect the M range switch.
•  If the M range switch is normal, inspect for continuity between the manual switch and TCM terminal 2B.
2
•  Verify test results.
―  If normal, return to the diagnostic index to service any additional symptoms.
―  If the malfunction remains, inspect the related Service Information and perform repair or diagnosis.
•  If the vehicle is repaired, troubleshooting is completed.
•  If the vehicle is not repaired or additional diagnostic information is not available, replace the TCM.