DTC B1D75:55

id080200828000

System Malfunction Location

• Configuration setting error (PAD switch structural malfunction)

Detection Condition

Warning

• Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.

• SAS control module configuration setting has not been done correctly

Possible Causes

• SAS control module configuration setting not implemented

• SAS control module configuration setting invalid

• PAD switch assembly incorrect

• SAS control module malfunction

Diagnostic Procedure

Step

Inspection

Action

1

PERFORM SAS CONTROL MODULE INSPECTION

•  Perform the configuration for the SAS control module using the M-MDS.
(See SAS CONTROL MODULE CONFIGURATION.)

•  Perform the DTC inspection for the SAS control module using the M-MDS.
(See DTC DISPLAY.)

•  Are the same DTCs present?

Yes

Perform the SAS control module configuration, then go to the next step.

(See SAS CONTROL MODULE CONFIGURATION.)

No

DTC troubleshooting completed.

2

INSPECT PAD SWITCH

•  Verify that the correct PAD switch is assembled.

•  Is the PAD switch installed correctly?

Yes

Go to the next step.

No

Install the PAD switch.

(See PASSENGER AIR BAG DEACTIVATION (PAD) SWITCH REMOVAL/INSTALLATION.)

3

PERFORM SAS CONTROL MODULE DTC INSPECTION

•  Perform the DTC inspection for the SAS control module using the M-MDS.
(See DTC DISPLAY.)

•  Are the same DTCs present?

Yes

Replace the SAS control module.

(See SAS CONTROL MODULE REMOVAL/INSTALLATION.)

No

DTC troubleshooting completed.

Step	Inspection		Action
1	PERFORM SAS CONTROL MODULE INSPECTION • Perform the configuration for the SAS control module using the M-MDS. (See SAS CONTROL MODULE CONFIGURATION.) • Perform the DTC inspection for the SAS control module using the M-MDS. (See DTC DISPLAY.) • Are the same DTCs present?	Yes	Perform the SAS control module configuration, then go to the next step. (See SAS CONTROL MODULE CONFIGURATION.)
1		No	DTC troubleshooting completed.
2	INSPECT PAD SWITCH • Verify that the correct PAD switch is assembled. • Is the PAD switch installed correctly?	Yes	Go to the next step.
2		No	Install the PAD switch. (See PASSENGER AIR BAG DEACTIVATION (PAD) SWITCH REMOVAL/INSTALLATION.)
3	PERFORM SAS CONTROL MODULE DTC INSPECTION • Perform the DTC inspection for the SAS control module using the M-MDS. (See DTC DISPLAY.) • Are the same DTCs present?	Yes	Replace the SAS control module. (See SAS CONTROL MODULE REMOVAL/INSTALLATION.)
3		No	DTC troubleshooting completed.