REAR ABS WHEEL-SPEED SENSOR INSPECTION
id041500800200
Installation Visual Inspection
1. Inspect the following items:
-
• If there is any malfunction, replace the applicable part.
- (1) Excessive looseness or play of the rear ABS wheel-speed sensor
- (2) Deformation of the rear ABS wheel-speed sensor
- (3) Deformation or damage of the rear ABS sensor rotor
Clearance Inspection
1. Verify the clearance between the rear ABS sensor rotor and the rear ABS wheel-speed sensor.
-
• If there is any malfunction, check for improper installation, and replace if necessary.
-
Clearance
-
0.8—1.6 mm {0.04—0.06 in}
Sensor Output Value Inspection
-
Caution
-
• Resistance inspection using other testers may cause damage to the ABS wheel-speed sensor internal circuit. Be sure to use the M-MDS to inspect the ABS wheel-speed sensor.
1. Turn the ignition switch off.
2. Connect the M-MDS to the DLC-2.
3. Select the following PIDs using the M-MDS:
-
• LR_WSPD
(LR wheel-speed sensor)
• RR_WSPD
(RR wheel-speed sensor)
4. Start the engine and drive the vehicle.
5. Verify that the display of the M-MDS shows the same value as the speedometer.
-
• If there is any malfunction, replace the rear ABS wheel-speed sensor.