REFERENCE INFORMATION [CAR-NAVIGATION SYSTEM]

id0903e8802600

Starting Procedure For Diagnostic Function

1.  Turn the ignition switch to the ON position.

2.  Press the MENU switch.

3.  Select “Navigation Set Up”.

4.  Select “Calibration”.

5.  Select “Map Version”.

6.  Press upper left of screen 2 times, then press lower left of it 2 times.

7.  Press “Menu” button of “Diagnosis Check” screen.

8.  Perform following procedures according to the purpose of the check item.

am6zzw00002627

No.	Display item	Description
1	PKB	Indicate parking brake signal. •  ON: Parking brake applied. •  OFF: Parking brake released.
2	REV	Indicate Reverse signal state. •  ON: Reverse •  OFF: Others
3	Microphone*	Indicate the connection state of a microphone. •  OK: Connect •  NCON: Disconnect
4	SPEED*	Indicate the present vehicle speed by kph/mph (a maximum of 3 digits)
5	TNS*	Indicate TNS signal state. •  ON: Turn TNS ON •  OFF: Turn TNS OFF
6	GPS Antenna*	Indicate the connection state of a GPS antenna. •  OK: Connect •  NCON: Disconnect
7	Traffic System	Indicate the RDS-TMC system availability on the vehicle. •  TMC: Equip •  NONE: Not equip

If inspect microphone related signals:

1.  Select “Navigation Check Menu”.

2.  Select “Microphone Check”.

am6zzw00002628

No.	Display item	Description
1	PPT switch status	indicate the state of a VOICE button. <OK>: Press the button (Keep the state of until the screen is changed.) <Please Push switch>: Other than above condition.
2	Microphone input level judging*	Indicate the test result. Green indicator: The sound is inputted from the microphone property. Gray indicator: The sound is inputted from the microphone improperly.
3	Microphone level	Indicate the input level of microphone by bar graph.

If inspect gyro sensor signals:

1.  Select “Navigation Check Menu”.

2.  Select “Vehicle Sensors”.

am6zzw00002815

No.	Display item	Description
1	GYRO	Indicate following gyro sensor signal. •  Gyro sensor signal voltage •  Relative bearing value