KEYLESS CONTROL MODULE REMOVAL/INSTALLATION

id091400806300

1.  If the keyless control module is replaced, always perform the following procedure.

•  Keyless Control Module Configuration (See KEYLESS CONTROL MODULE CONFIGURATION.)

•  Immobilizer system-related parts programming [No.5 Programming Procedure Due to Keyless Control Module Replacement] (See IMMOBILIZER SYSTEM-RELATED PARTS PROGRAMMING [WITH KEYLESS ENTRY SYSTEM].)

2.  Disconnect the negative battery cable.

3.  Remove the glove compartment. (See GLOVE COMPARTMENT REMOVAL/INSTALLATION.)

4.  Remove the bolts.

ar8wzw00000834

5.  Remove the connector clip installed to the bracket by shifting the keyless control module downward.

6.  Disconnect the keyless control module connector.

7.  Install in the reverse order of removal.