FRONT BELTLINE MOLDING REMOVAL/INSTALLATION


id091600804800

1.  Remove the inner garnish. (See INNER GARNISH REMOVAL/INSTALLATION.)

2.  Loosen the power outer mirror installation screws and move the mirror to access the front end of the front beltline molding. (See POWER OUTER MIRROR REMOVAL/INSTALLATION.)

3.  While partially peeling back the front beltline molding, detach tabs A along the direction (1) shown in the figure.

ar8uuw00001953

4.  Remove clip B and front beltline molding.

5.  Install in the reverse order of removal.