2-4 BRAKE PREINSPECTION
BHE051319500A09
Clutch Operation Inspection
-
Warning
-
• Using compressed air can cause dirt and other particles to fly out, causing injury to the eyes. Wear protective eye wear whenever using compressed air.
-
Caution
-
• Applying compressed air to the assembled clutch pack for more than 3 s at a time will damage the seal.
-
• Do not apply compressed air for more than the aforementioned time when testing the system.
1. Apply compressed air to the part indicated in the figure and inspect the 2-4 brake operation.
-
• If there is any malfunction, inspect the seal rings.
-
Air pressure
-
390 kPa {4.0 kgf/cm2, 57 psi} max.
2. Measure the clearance between the 2-4 brake retainer and the snap ring.
-
• If the clearance is not within the specification, adjust the clearance by installing the correct retaining plate.
-
Specification
-
1.0-1.4 mm {0.0394-0.0551 in}
-
Retaining plate sizes (13B-MSP)
mm {in}
|
5.2 {0.205}
|
5.4 {0.213}
|
5.6 {0.220}
|
|
5.8 {0.228}
|
6.0 {0.236}
|
6.2 {0.244}
|
-
Retaining plate sizes (FE CIS)
mm {in}
|
5.4 {0.213}
|
5.6 {0.220}
|
5.8 {0.228}
|
|
6.0 {0.236}
|
6.2 {0.244}
|
6.4 {0.252}
|
