KEYLESS CONTROL MODULE OUTLINE

id091400102400

•  Controls the following systems:
―  Power door lock system
―  Keyless entry system
―  Interior light control system
―  Immobilizer system
―  Theft-deterrent system
•  Supplies power to the front seat belt lock release system.
•  An on-board diagnostic system, which can determine if the input/output signals in the keyless entry system are normal, has been adopted. The on-board diagnostic system is initiated by the key reminder switch, ignition switch and driver-side door switch, and the following operations can be verified. Refer to the Mazda RX-8 Workshop Manual (1767-1*-03D) for detailed procedures and descriptions regarding the operations.
―  Lock/unlock operation of door lock actuator for all doors
―  Trunk lid opener unlock operation
―  Hazard light flashing
•  When replacing the keyless unit for vehicles with the immobilizer system, initialization configuration according to the vehicle information and immobilizer system resetting are required. Refer to the Mazda RX-8 Workshop Manual for detailed procedures and descriptions regarding the operations.
bhe0914t364

1
Keyless control module
2
Buckle switch
3
Lock release solenoid
4
Instrument cluster
5
Door switch (driver's side)
6
Door switch (passenger's side)
7
Rear door lower latch switch
8
Rear door upper latch switch
9
Key reminder switch
10
Door lock-link switch (driver's side)
11
Door lock-link switch (passenger's side)
12
Door key cylinder
13
Internal antenna
14
Coil
15
Map light
16
Interior light
17
Courtesy light
18
Ground illumination light
19
Instrument cluster (security light)
20
Flasher unit
21
Hazard warning switch
22
Bonnet latch switch
23
Front door lock actuator
24
Driver's side
25
Passenger's side
26
Trunk compartment light
27
Trunk compartment light switch
28
Trunk lid opener relay
29
Trunk lid opener cancel switch
30
Trunk lid opener
31
Trunk lid opener switch
32
Intruder sensor
33
Theft-deterrent siren
34
Vehicles with theft-deterrent system