TORQUE CONVERTER INSPECTION
BUE051700000116
1. A new torque converter must be installed if one or more of the following conditions is met:
-
• A torque converter malfunction has been detected based on completed diagnostic procedures.
-
Note
-
• Stud threads can be repaired using a thread chaser.
-
• Converter stud(s), impeller hub or bushing is damaged.
-
• There is a discoloration of the torque converter (due to overheating).
-
• The torque converter is found to be out of specification, when performing the following inspections:
-
- Torque converter pump insert inspection
-
- Torque converter end play inspection
-
- Torque converter turbine torque inspection
-
- Torque converter leakage inspection
-
• There is evidence of transaxle component damage or fluid contamination due to the following transaxle or converter failure modes:
-
- Major metallic failure
-
- Multiple clutches or clutch plate failures
-
- Component wear which results in metallic contamination