DTC P0607[L3]
id0102a2809500
|
DTC P0607 |
PCM performance problem |
|---|---|
|
DETECTION CONDITION
|
• PCM internal malfunction.
Diagnostic support note
• This is a continuous monitor (Other).
• The MIL does not comes on.
• PENDING CODE is available if PCM detects the above malfunction condition.
• FREEZE FRAME DATA is not available.
• DTC is stored in PCM memory.
|
|
POSSIBLE CAUSE
|
• PCM internal malfunction
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY FREEZE FRAME DATA AND DIAGNOSTIC MONITORING TEST RESULTS HAS BEEN RECORDED
• Has FREEZE FRAME DATA been recorded?
|
Yes
|
Go to the next step.
|
|
No
|
Record the FREEZE FRAME on the repair order, then go to the next step.
|
||
|
2
|
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
• Verify related Service Information availability.
• Is any related Service Information available?
|
Yes
|
Perform repair or diagnosis according to the available Service Information.
If the vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY TROUBLESHOOTING OF P0607 COMPLETED
• Make sure to reconnect all disconnected connectors.
• Clear the DTC from PCM memory using the M-MDS.
• Start the engine.
• Is the same DTC present?
|
Yes
|
Replace the PCM, go to the next step.
(See PCM REMOVAL/INSTALLATION[L3].)
|
|
No
|
Go to the next step.
|
||
|
4
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the “AFTER REPAIR PROCEDURE”.
(See AFTER REPAIR PROCEDURE[L3].)
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE[L3].)
|
|
No
|
Troubleshooting completed.
|
||