DTC P1125[AJ (3.0L Duratec)]
id0102a4822900
DTC P1125 |
TP sensor intermittent |
---|---|
DETECTION CONDITION
|
• Indicates TP sensor signal was intermittent.
|
POSSIBLE CAUSE
|
• TP sensor malfunction
• PCM malfunction
|
Diagnostic procedure
STEP |
INSPECTION |
ACTION |
|
---|---|---|---|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has FREEZE FRAME DATA been recorded?
|
Yes
|
Go to next step.
|
No
|
Record FREEZE FRAME DATA on repair order, then go to next step.
|
||
2
|
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
• Check for related Service Information availability.
• Is any related Service Information available?
|
Yes
|
Perform repair or diagnosis according to available Service Information.
• If vehicle is not repaired, go to next step.
|
No
|
Go to next step.
|
||
3
|
VERIFY OTHER DTC PRESENT
• Is DTC P0122 or P0123 present?
|
Yes
|
Go to applicable DTC inspection.
(See DTC TABLE[AJ (3.0L Duratec)].)
|
No
|
Go to next step.
|
||
4
|
INSPECT TP SENSOR
• Inspect the TP sensor.
• Is there any malfunction?
|
Yes
|
Replace throttle body, then go to next step.
|
No
|
Go to next step.
|
||
5
|
VERIFY TROUBLESHOOTING OF DTC P1125 COMPLETED
• Make sure to reconnect all disconnected connectors.
• Clear DTC from memory using M-MDS.
• Start engine.
• Perform “KOEO/KOER self-test”
• Is same DTC present?
|
Yes
|
Replace PCM, then go to next step.
|
No
|
Go to next step.
|
||
6
|
VERIFY AFTER REPAIR PROCEDURE
• Perform "AFTER REPAIR PROCEDURE".
• Is there any DTC present?
|
Yes
|
Go to applicable DTC inspection.
(See DTC TABLE[AJ (3.0L Duratec)].)
|
No
|
Troubleshooting completed.
|