DTC P1309[AJ (3.0L Duratec)]
id0102a4824700
DTC P1309 |
MIsfire monitor disabled |
---|---|
DETECTION CONDITION
|
• Incomprehensible signals from CMP sensor.
|
POSSIBLE CAUSE
|
• CMP sensor malfunction
• CKP sensor malfunction
• ECT sensor malfunction
• MAF sensor malfunction
• PCM malfunction
|
Diagnostic procedure
STEP |
INSPECTION |
ACTION |
|
---|---|---|---|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has FREEZE FRAME DATA been recorded?
|
Yes
|
Go to next step.
|
No
|
Record FREEZE FRAME DATA on repair order, then go to next step.
|
||
2
|
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
• Check for related Service Information availability.
• Is any related Service Information available?
|
Yes
|
Perform repair or diagnosis according to available Service Information.
• If vehicle is not repaired, go to next step.
|
No
|
Go to next step.
|
||
3
|
VERIFY OTHER DTC PRESENT
• Is DTC P0102, P0103, P0117, P0118, P0320, or P0340?
|
Yes
|
Go to applicable DTC inspection.
(See DTC TABLE[AJ (3.0L Duratec)].)
|
No
|
Go to next step.
|
||
4
|
INSPECT CMP SENSOR INSTALLATION
• Inspect the CMP sensor installation.
• Is there any malfunction?
|
Yes
|
Install the CMP sensor, then go to next step.
|
No
|
Go to next step.
|
||
5
|
VERIFY TROUBLESHOOTING OF DTC P1309 COMPLETED
• Make sure to reconnect all disconnected connectors.
• Clear DTC from memory using M-MDS.
• Start engine.
• Is same DTC present?
|
Yes
|
Replace PCM, then go to next step.
|
No
|
Go to next step.
|
||
6
|
VERIFY AFTER REPAIR PROCEDURE
• Perform "AFTER REPAIR PROCEDURE".
• Is there any DTC present?
|
Yes
|
Go to applicable DTC inspection.
(See DTC TABLE[AJ (3.0L Duratec)].)
|
No
|
Troubleshooting completed.
|