NO.7 SLOW RETURN TO IDLE[L3]

id0103a4801300

7

SLOW RETURN TO IDLE
DESCRIPTION
Engine takes more time than normal to return to idle speed.
POSSIBLE CAUSE
•  ECT sensor malfunction
•  Thermostat is stuck open.
•  Throttle body malfunction
•  Air leakage from intake-air system

Diagnostic procedure

STEP

INSPECTION

RESULTS

ACTION
1
Connect the M-MDS to the DLC-2.
Turn the ignition switch to the ON position (Engine off).
Retrieve any DTCs.
Are there any DTCs displayed?
Yes
DTC is displayed:
Go to the appropriate DTC inspection.
(See DTC TABLE[L3].)
No
No DTC is displayed:
Go to the next step.
2
Remove thermostat and inspect operation.
(See THERMOSTAT REMOVAL/INSTALLATION[L3].)
(See THERMOSTAT INSPECTION[L3].)
Is thermostat normal?
Yes
ECT and thermostat are normal.
Go to the next step.
No
Access ECT PID on the M-MDS.
Inspect for both ECT PID and temperature gauge on instrument cluster readings.
If temperature gauge on instrument cluster indicates normal range but ECT PID is not same as temperature gauge reading, inspect ECT sensor.
If temperature gauge on instrument cluster indicates cold range but ECT PID is normal, inspect temperature gauge and heat gauge unit.
3
Is throttle body free of contamination?
Yes
Inspect for air leakage from the intake-air system components while racing the engine to higher speed.
No
Clean or replace throttle body.
4
•  Verify test results.
―  If normal, return to diagnostic index to service any additional symptoms.
―  If malfunction remains, inspect related Service Information and perform repair or diagnosis.
•  If vehicle is repaired, troubleshooting completed.
•  If vehicle is not repaired or additional diagnostic information is not available, replace the PCM.