No.3 ENGINE MOUNT REMOVAL/INSTALLATION[AJ (3.0L Duratec)]


id0110a3802300


Removal/Installation

1.  Disconnect the negative battery cable.

2.  Remove the power steering pressure hose bracket.

atraaw00000058

3.  Assemble two SSTs using the bolt (M6) and nut, then install them in the position shown in the figure for the cylinder head (RH).

atraaw00003128

Caution
•  Refer to the SST instruction manual for the basic handing procedure.

4.  Install the SST using the following procedure.

atraaw00002180

(1)  Install the right rear shaft of the SST to the bolt of the right shock absorber as shown in the figure.
atraaw00000060
(2)  Install the left rear shaft of the SST to the bolt of the left shock absorber. (Identical position to the right side)
(3)  Install the left/right front shaft of the SST with front foot No.2 to the bolt as shown in the figure.
atraaw00003129
(4)  Adjust the positions of the SST side bars so that they are the same height (left and right) and horizontal.
(5)  Make sure each joint is securely tightened.

Caution
•  If the SSTs installed to the cylinder head (RH) interfere with the brake pipe, the brake pipe could be damaged. Do not allow the SSTs to interfere with the brake pipe.
atraaw00000062
Note
•  The SST (49 E017 5A0) can be used in place of the SST (49 C017 5A0).

5.  Support the engine using the SST.

atraaw00002450

6.  Position the power pressure steering line and bracket out of the way.

atraaw00000066

7.  Remove the bolts and nuts, and then remove the No.3 engine mount bracket.

atraaw00000071

8.  Install in the reverse order of removal.