CYLINDER HEAD COVER (LH) REMOVAL/INSTALLATION[AJ (3.0L Duratec)]

id0110a3802600

Removal

1.  Remove the plug hole plate.

2.  Disconnect the crankcase ventilation tube from the cylinder head cover.

3.  Remove the ignition coils (LH).

atraaw00000362

(1)  Disconnect the connector.

(2)  Remove the bolt.

(3)  Remove the ignition coil.

4.  Disconnect the wiring harness from the cylinder head cover studs.

atraaw00000363

5.  Remove the engine hanger.

atraaw00000364

6.  Remove the cylinder head cover bolts and studs in the order shown.

atraaw00000639

Installation

1.  Position a new gasket on the cylinder head cover.

2.  Apply a 8 mm {0.32 in} dot of Silicone Gasket Sealant to the front cover to cylinder head joints.

atraaw00000640

Note

•  The cylinder head cover must be installed and the bolts tightened within six minutes of applying the sealant.

3.  Position the cylinder head cover and install the studs and the bolts in the sequence shown.

atraaw00000641

4.  Position the engine hanger and install the bolt.

atraaw00000368

5.  Connect the wiring harness to the cylinder head cover studs.

atraaw00000363

6.  Install the ignition coils (LH).

atraaw00000995

(1)  Position the ignition coil.

(2)  Install the bolt.

(3)  Connect the connector.

7.  Connect the crankcase ventilation tube to the cylinder head cover.

8.  Install the plug hole plate.