WATER PUMP REMOVAL/INSTALLATION[L3]
id0112a1800700
1. Disconnect the negative battery cable.
2. Remove the splash shield (LH).
3. Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT[L3].)
4. Remove the splash shield (RH).
5. Loosen the water pump pulley bolts before removing the drive belt.
6. Remove the drive belt. (See DRIVE BELT REMOVAL/INSTALLATION[L3].)
7. Remove in the order indicated in the table.
8. Install in the reverse order of removal.
9. Refill the engine coolant. (See ENGINE COOLANT REPLACEMENT[L3].)
10. Inspect for engine coolant leakage. (See ENGINE COOLANT LEAKAGE INSPECTION[L3].)
atraaw00000459
|
1
|
Water pump pulley
|
2
|
Water pump
|
3
|
O-ring
(See O-ring Installation Note.)
|
O-ring Installation Note
1. Apply engine coolant to a new O-ring.
2. Install the O-ring.