WATER PUMP REMOVAL/INSTALLATION[AJ (3.0L Duratec)]
id0112a2800700
1. Remove the battery. (See BATTERY REMOVAL/INSTALLATION[AJ (3.0L Duratec)].)
2. Remove the splash shield (RH).
3. Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT[AJ (3.0L Duratec)].)
4. Remove the water pump drive pulley. (See CAMSHAFT (LH) REMOVAL/INSTALLATION[AJ (3.0L Duratec)].)
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
7. Refill the engine coolant. (See ENGINE COOLANT REPLACEMENT[AJ (3.0L Duratec)].)
8. Inspect for engine coolant leakage. (See ENGINE COOLANT LEAKAGE INSPECTION[AJ (3.0L Duratec)].)
atraaw00000478
|
1
|
Thermostat case component
|
2
|
Oil cooler water hose
|
3
|
Water outlet hose
|
4
|
Water pump
(See Water Pump Installation Note.)
|
Water Pump Installation Note
1. Tighten the bolts to the specified tightening torque, then tighten them further 85—95 °.