COOLING FAN COMPONENT REMOVAL/INSTALLATION[AJ (3.0L Duratec)]

id0112a2802500

Warning

• Remove and install all parts when the engine is cold, otherwise they can cause severe burns or serious injury.

1. Disconnect the negative battery cable.

2. Position the splash shield (RH) out of the way.

3. Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION.)

4. Remove in the order indicated in the table.

5. Install in the reverse order of removal.

atraaw00002340

1

Radiator bracket

2

Radiator seal plate

3

Hood latch

(See Hood Latch Removal Note.)

4

Center support

(See Center Support Removal Note.)

5

Connector

6

P/S cooling pipe

(See P/S Cooling Pipe Removal Note.)

7

ATF oil cooler

(See ATF Oil Cooler Removal Note.)

8

ATF oil cooler hose

9

Cooling fan component

(See Cooling Fan Component Removal Note.)

Hood Latch Removal Note

1. Remove the hood latch with the cable still connected. Position the hood latch so that it is out of the way.

atraaw00002341

Center Support Removal Note

1. Remove the two bolts and the center support.

atraaw00002342

P/S Cooling Pipe Removal Note

1. Remove the P/S cooling pipe with the hoses still connected.

ATF Oil Cooler Removal Note

1. Remove the ATF oil cooler with the hoses still connected.

Cooling Fan Component Removal Note

1. Move the condenser toward the front of vehicle to make space.

2. Move the radiator toward the front of vehicle to make space.

3. Remove the cooling fan component from above the engine compartment.

1	Radiator bracket
2	Radiator seal plate
3	Hood latch (See Hood Latch Removal Note.)
4	Center support (See Center Support Removal Note.)
5	Connector
6	P/S cooling pipe (See P/S Cooling Pipe Removal Note.)
7	ATF oil cooler (See ATF Oil Cooler Removal Note.)
8	ATF oil cooler hose
9	Cooling fan component (See Cooling Fan Component Removal Note.)