DYNAMIC CHAMBER REMOVAL/INSTALLATION[AJ (3.0L Duratec)]

id0113a1802100

1.  Disconnect the negative battery cable.

2.  Remove the plug hole plate.

atraaw00000086

3.  Remove the air hose. (See AIR HOSE REMOVAL/INSTALLATION[AJ (3.0L Duratec)].)

4.  Detach the throttle cable from the throttle body.

atraaw00000087

5.  Detach the speed control cable from the throttle body. (Only vehicles with speed control cable)

6.  Remove the throttle cable bracket bolts.

7.  Disconnect the throttle position (TP) sensor and idle air control (IAC) solenoid valve connector.

atraaw00000088

8.  Remove the EGR valve vacuum hose and EGR pipe nut.

atraaw00001001

9.  Disconnect the following hoses or connectors

(1)  EGR control valve connector and vacuum hose

atraaw00000090

(2)  Three vacuum hoses located behind the dynamic chamber

(3)  Purge solenoid valve vacuum hose

atraaw00000092

(4)  Two connectors installed on the left side of the dynamic chamber

atraaw00000093

(5)  Power steering pressure (PSP) switch connector

atraaw00000094

10.  Remove the dynamic chamber installation bolts and dynamic chamber.

atraaw00000095

Note

•  If the gasket is damaged, replace with a new one.

•  Clean all of the sealing surfaces.

11.  Install in the reverse order of removal.