BRAKE SWITCH 2 REMOVAL/NSTALLATION[AJ (3.0L Duratec)]
id0120a4106000
Removal
1. Disconnect the negative battery cable.
2. Remove the brake switch 2.
- (1) Disconnect the brake switch 2 connector.
-
- (2) Rotate counterclockwise 45 degrees and remove the brake switch 2.
-
Installation
-
Caution
-
• Initial installation of a brake switch 2 allows for one adjustment. If additional adjustments are required, install a new switch.
1. Release the plunger lock.
-
• Turn the lock knob counterclockwise until the first click is felt.
2. Depress the brake pedal.
3. Install the brake switch 2.
- (1) Position the brake switch 2 in the bracket and rotate clockwise 45 degrees.
-
- (2) Connect the brake switch 2 connector.
-
4. Slowly release the brake pedal and tug moderately once the pedal reaches the rest position.
-
Note
-
• There should be an extra click heard when tugging on the brake pedal.