RESERVE TANK REMOVAL/INSTALLATION
id041100803300
-
Warning
-
• Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
-
Caution
-
• Brake fluid will damage painted surfaces. Be careful not to spill any on painted surfaces. If brake fluid is spilled, wipe it off immediately.
Removal
1. Disconnect the brake fluid level sensor connector.
2. Using a suitable suction device, drain the reserve tank.
3. Remove the reserve tank.
Installation
-
Note
-
• Whenever installing a new master cylinder, install new seals.
1. Install the reserve tank.
- (1) Lubricate the two seals with clean brake fluid and insert the seals into the master cylinder.
-
- (2) Press the reserve tank into the seals until it snaps in securely.
-
- (3) Connect the brake fluid level sensor connector.
-
2. Bleed the master cylinder. (See AIR BLEEDING (BRAKE SYSTEM).)