RETURN HOSE REMOVAL/INSTALLATION[AJ (3.0L Duratec)]

id0614008018a4

Removal/Installation

1.  Disconnect the power steering return line from the steering gear.

Note

•  Drain excess power steering fluid into an appropriate container.

•  Do not drop the O-ring seal.

2.  Release the clamp, then disconnect and remove the power steering return line.

3.  Install in the reverse order of removal.

Note

•  Verify that the O-ring seal is installed on the power steering return line.

4.  Add power steering fluid, bleed the system, and then inspect the system for leakage.