CONDENSER REMOVAL/INSTALLATION

id071100801200

Note

•  Installation of a new receiver/drier is not necessary when repairing the air conditioning system except when there is physical evidence of system contamination from a failed A/C component or damage to the receiver/drier.

•  If an condenser leak is suspected, the condenser must be leak tested before it is removed from the vehicle. (See EVAPORATOR/CONDENSER INSPECTION.)

1.  Discharge the refrigerant from the system. (See DISCHARGING AND RECOVERY.)

2.  Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION.)

3.  Remove the nuts from the two condenser fitting.

aesffw00000305

Caution

•  Plug all ports to prevent contamination from dirt or moisture.

4.  Remove the nuts and the condenser bracket.

atraaw00003080

5.  Remove the condenser.

Note

•  When removing the condenser, disconnect the two air conditioner line (block-type) fittings from condenser.

6.  Install in the reverse order of removal.

(1)  Lubricate the new A/C compressor with the correct amount of PAG Compressor Oil. (See COMPRESSOR OIL ADDING.)

(2)  Lubricate the new O-ring with PAG Compressor Oil.