A/C COMPRESSOR REMOVAL/INSTALLATION [AJ (3.0L Duratec)]

id071100804000

Caution

•  To prevent refrigerant system contamination, if you are installing a new A/C compressor because the A/C compressor has failed internally, you must use the following procedures:

Note

•  Installation of a new receiver/drier is not necessary when repairing the air conditioning system except when there is physical evidence of system contamination from a failed A/C compressor or damage to the receiver/drier.

1.  If an A/C Flusher is available, carry out the air conditioning (A/C) system flushing general procedure. (See A/C SYSTEM FLUSHING.)

2.  If the A/C Flusher is not available, carry out the refrigerant system filtering following A/C component installation general procedure. (See REFRIGERANT SYSTEM FILTERING FOLLOWING A/C COMPONENT INSTALLATION.)

3.  Remove the drive belt. (See DRIVE BELT REMOVAL/INSTALLATION[AJ (3.0L Duratec)].)

4.  If equipped, disconnect the engine block heater electrical connector.

aesffw00000099

5.  Disconnect the magnetic clutch connector.

aesffw00000100

6.  Remove the refrigerant line installation bolt from the top of the A/C compressor and disconnect the refrigerant line.

atraaw00003036

Caution

•  Plug all ports to prevent contamination from dirt or moisture.

7.  Remove the bolts and the A/C compressor.

aesffw00000307

8.  Install in the reverse order of removal.

(1)  Lubricate the new A/C compressor with the correct amount of PAG Compressor Oil. (See COMPRESSOR OIL ADDING.)

(2)  Lubricate the new O-ring with PAG Compressor Oil.

(3)  Apply Pipe Sealant.