PRESSURE RELIEF VALVE REMOVAL/INSTALLATION


id071100804300

1.  Discharge the refrigerant from the system. (See DISCHARGING AND RECOVERY.)

2.  Raise and support the vehicle.

3.  Remove the RH splash shield.

aesffw00000107

4.  If equipped, disconnect the engine block heater connector.

aesffw00000108

5.  Remove the A/C manifold and tube installation bolt, then disconnect the A/C manifold and tube. (AJ (3.0L Duratec))

atraaw00003039

Caution
•  Plug all ports to prevent contamination from dirt or moisture.

6.  Remove the pressure relief valve.

aesffw00000110

Note
•  Vehicle with AJ (3.0L Duratec) engine shown.

7.  Install in the reverse order of removal.

(1)  Lubricate the new O-ring with PAG Compressor Oil.