SEAT BELT SHOULDER HEIGHT ADJUSTER REMOVAL/INSTALLATION


id081100801700

Warning
•  All seat belt components including seat belt retractors/buckles/anchors, seat belt shoulder height adjusters (if equipped), child seat anchors, and installation hardware should be inspected after any collision. All seat belt components should be replaced unless a qualified technician finds the components show no damage and operate properly. Seat belt components not in use during a collision should also be inspected and replaced if either damage or improper operation is noted.
Note
•  The passenger’s seat is shown in the figure. The driver’s seat is the same as the passenger’s seat.

1.  Remove the B pillar trim. (See B-PILLAR TRIM REMOVAL/INSTALLATION.)

2.  Lower the height adjuster.

3.  Remove the height adjuster upper bolt.

atraaw00001463

4.  Raise the height adjuster.

5.  Remove the height adjuster.

atraaw00001464

(1)  Remove the height adjuster lower bolt.
(2)  Remove the height adjuster.

6.  Install in the reverse order of removal.

•  Verify that the front seat belt retractor is not in the Automatic Locking Retractor (ALR) mode.
Note
•  Before installing, verify that the seat belt is not twisted.
•  Tighten the bolts to the specified torque.

7.  Inspect the seat belt system for normal operation.

•  To verify that the new retractor is operating normally, perform the Emergency Locking Retractor (ELR) mode functional test.