DTC B1600[IMMOBILIZER SYSTEM (PATS) (AJ (3.0L Duratec))]

id0902g3807900


Detection Condition

•  The key ID number data cannot be read.

Possible Cause

•  No transponder in the key
•  Transponder malfunction (Key ID number is not output)
•  Coil malfunction
•  PCM malfunction
•  Communication error
Note
•  Large metallic objects, electronic devices on the key chain, or a second key on the same key ring as the immobilizer system ignition key may cause vehicle starting concerns and record DTCs under certain conditions. If a fault cannot be identified, examine the customer’s key ring for such objects or devices. If present, inform the customer that they need to keep these objects from touching the immobilizer system ignition key while starting the engine. These objects and devices cannot damage the immobilizer system ignition key, but can cause a momentary problem if they are too close to the key during engine start. If a problem occurs, turn the ignition switch off and restart the engine with all other objects on the key ring held away from the ignition key. Verify that the encoded ignition key used by the customer is an encoded ignition key.

Diagnostic Procedure

STEP

INSPECTION

ACTION
1
VERIFY DTC USING M-MDS
•  Is DTC B1600 displayed?
Yes
Go to the next step.
No
The system is normal.
2
VERIFY WHETHER MALFUNCTION IS IN KEY OR COIL ANTENNA
•  Using the M-MDS, program an additional key.
•  Using the programmed key, turn the ignition switch to the ON position.
•  Using the M-MDS, verify if any DTCs are displayed.
―  Is DTC B1600 displayed again?
Yes
Replace the coil antenna, then go to the next step.
(See COIL ANTENNA REMOVAL/INSTALLATION.)
No
•  Dispose of the malfunctioning key.
•  Program a new key if necessary.
3
INSPECT THE PCM
•  Using the programmed key, turn the ignition switch to the ON position.
•  Using the M-MDS, verify if any DTCs are displayed.
―  Is DTC B1600 displayed again?
Yes
Replace the PCM and perform the resetting procedure for the immobilizer system when replacing the PCM.
(See IMMOBILIZER SYSTEM (PATS) COMPONENT REPLACEMENT/KEY ADDITION AND CLEARING[AJ (3.0L Duratec)].)
No
DTC inspection completed.