TRANSMITTER ID CODE PROGRAMMING


id091400809300

Note
•  All transmitters must be programmed at the same time.

1.  The vehicle must be electronically unlocked before entering program mode (via transmitter), keyless entry keypad (if equipped) or door lock switch while the driver’s side door is open.

2.  Turn the ignition switch from LOCK position to ON position 8 times within 10 seconds, with the eighth turn ending in ON position. If the module has successfully entered program mode, it will lock and then unlock all doors.

3.  Within 20 seconds, press any button on a transmitter, and the doors will lock and then unlock to confirm that each remote transmitter has been programmed. Repeat this step for each transmitter.

4.  If the door locks do not respond for any transmitter, wait several seconds and press the button again. If the door locks still fail to respond, refer to inspection and verification. Make sure that no more than the maximum number of transmitters are attempted to be programmed.

5.  Exiting the programming mode is accomplished if one of the following occurs:

•  The ignition switch transitions to the LOCK position.
•  20 seconds have passed since entering programming mode or since the last transmitter was programmed.
•  The maximum number of tranmitters have been programmed.