PID/DATA MONITOR AND RECORD PROCEDURE[AJ (3.0L Duratec)]


id0922008006a7

1.  Connect the M-MDS or equivalent to the DLC-2 (16-pin).

atraaw00001951

2.  After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

When using the IDS (notebook PC)
•  Select the “Toolbox” tab.
•  Select “DataLogger”.
•  Select “Module”.
•  Select “IC”.
When using the PDS (pocket PC)
•  Select “Module Tests”.
•  Select “IC”.
•  Select “DataLogger”.


Display Table

PID name

Input/output signal/Part name

Unit/Status

Terminal

ABCHIME
Air bag system warning alarm
On/Off
1P
CCNT_IC
DTC
Amount of codes detected
CHIME_REQ
External chime request
On/Off
DIMMER
Panel light control status
Increase/ Decrease/ Off
DIMMER_S3
Dimmer switch
2K
ENGCOOLAN
Engine coolant level
LOW/OK
Fuel
Fuel level
%
HD_LMP_S3
Light switch status
Off/ Rfog/ P/ Headlamp/ Invalid
D_DR_SW
Driver"s seat door lock switch
Ajar/ Closed
2L
LFSBELT
Driver"s seat seat belt retractor switch
Buckled/ Unbuckled
1K
ODOMETER
Distance travelled
km
mile
PARK_INPT
Parking brake switch
Parked/ Not Park
1B
RES_SW
Odometer/tripmeter switch
ON/OFF
TRANSGEAR
Selector lever position
P/ Reverse/ Neutral/ Drive 1/ Drive 2/ Drive 3/Unknown/Invalid
VBAT_#1
Battery positive voltage
V
V
3K
VIC_RESET
Odometer/tripmeter switch
Reset/ Off
Reset/ Off