CYLINDER BLOCK INSPECTION

1. Measure the cylinder bore at the top and bottom. Verify the cylinder bore is within the wear limit. The difference indicates the cylinder bore taper. Bore the cylinder to the next oversize.

Maximum bore diameter

Class-1: 84.800-84.810 mm {3.338576-3.3389697 in}

Class-2: 84.810-84.820 mm {3.3389697-3.3393634 in}

Class-3: 84.820-84.830 mm {3.3393634-3.3397571 in}

2. Measure the cylinder bore in two directions. The difference is the out-of-round. Verify the out-of-round is within the wear limit and bore the cylinder to the next oversize limit.

Maximum out-of-round

0.025 mm {0.0009842 in}